Comtrol RocketPort Serial Hub Si Driver Installation for W Uživatelský manuál stáhnout pdf (Strana 4)

Removing an Existing Device and Driver 4

Driver Installation and Configuration

This subsection discusses the following installation and configuration issues:

• Removing an existing device and driver (discussed below)

• Installing

the software

• Verifying

the installation

•Using port sharing

• Changing configuration parameters

• Adding

new RocketPort Serial Hub Si devices to an existing configuration

• “Hot-swapping”

devices

See Initial Installation - Quick Reference

, if you want to install the product using a quick reference.

Removing an Existing Device and Driver

Use the following procedure to remove any existing RocketPort Serial Hub Si devices and drivers on the

Windows 95/98 operating system. If updating (not reconfiguring) the driver, you may skip Steps 1 through 8

and leave the devices installed, but make sure that you remove the existing driver before installing an

updated driver.

1. Right-click on My Computer, and select Properties.

2. Select the Device Manager tab.

3. Expand the

Multi-function adapters

node of the device tree.

4. Highlight

RocketPort Serial Hub Si 4/8 Port Device

1 2 3 4 5 6 7 8 9 ... 46 47

Žádné komentáře

Comtrol RocketPort Serial Hub Si Driver Installation for W Uživatelský manuál Strana 4