Comtrol DeviceMaster NS-Link Uživatelský manuál stáhnout pdf (Strana 14)

14 - Uploading SocketServer DeviceMaster Driver User Guide: 2000595 Rev. A

Before Installing the Comtrol Drivers Management Console

Uploading SocketServer

The NS-Link device driver loads the current firmware but not until the

DeviceMaster has shown that an old version of the SocketServer (older than 8.00)

or any firmware other than NS-Link Updater is running. The driver does not

upload anything unless it first connects to the default application (SocketServer)

on the DeviceMaster.

Note: If you are familiar with the NS-Link driver, you may want to review

information for

existing customers.

Optionally, you can upload the appropriate version of SocketServer after running

the NS-Link device driver Installation Setup Wizard.

Use the following procedure to upload the latest SocketServer version using

PortVision DX.

1. Start PortVision DX, click: Start > Programs > Comtrol > PortVision DX >

PortVision DX.

2. Right-click the DeviceMaster or DeviceMasters of which you want to upload

the latest version of SocketServer and then click Advanced > Upload Firmware.

3. Browse to the location where you downloaded SocketServer, highlight the file,

and click Open.

4. Click Ye s to the Upload Firmware

popup.

5. Click Ye s to the second Upload

Firmware popup.

You can click Refresh to verify that

the upload has been successfully

completed.

If the upload fails, use the PortVision

DX General tab on the Properties

screen to change the Bootloader

Timeout to 45 seconds and then repeat

Steps 2 through 5.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 87 88

Žádné komentáře

Comtrol DeviceMaster NS-Link Uživatelský manuál Strana 14